Security; Troubleshooting Tips - Dodge 2009 Avenger Owner's Manual

152 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
has successfully accepted the frequency signal. The
indicator light will flash slowly and then rapidly when
fully trained.
If you unplugged the device for training, plug it back in
at this time.
Then proceed with Step 4 under "Programming
HomeLink ," earlier in this section.

Security

It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for
20 seconds until the red indicator flashes. Note that all
channels will be erased. Individual channels cannot be
erased.
The HomeLink Universal Transceiver is disabled when
the Vehicle Security Alarm is active.

Troubleshooting Tips

If you are having trouble programming HomeLink , here
are some of the most common solutions:
Replace the battery in the original transmitter.
Press the "Learn" button on the Garage Door Opener
to complete the training for a Rolling Code.
Did you unplug the device for training, and remember
to plug it back in?
If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.