Op X/Z, X1/Z1,X2/Z2 Mode - Sharp ER-A450T Programming Manual

CHAPTER 3. OP X/Z, X1/Z1,X2/Z2 MODE
The following categories of reports can be printed by the ECR.
OP X/Z reports: These reports are taken by operators in order to
report their own sales data.
XI/Z1 reports: These reports are taken by the supervisor or man-
ager in order to check and report daily sales totals
at that point.
X2/Z2 reports: These reports are taken by the owner or manager
in order to check and report periodic (weekly or
monthly) totals.
REPORT NAME
GENERAL
UPC (All)
(Pick up)
UPC BY DEPT.
UPC ZERO SALES (All)
(By DEPT.)
DEPT./GROUP
IND. GROUP
GROUP TOTAL
PLU BY RANGE
PLU BY DEPT.
PLU ZERO SALES (All)
(By DEPT.)
PLU PRICE CATEGORY
TRANSACTION
CID
ALL CASHIER
IND. CASHIER
HOURLY (All)
(Range)
DAILY NET
PBLU
PBLU BY CASHIER
STACKED REPORT
DEPT. SALES (Frash-read)
CID (Frash-read)
DAILY MET SALES (Frash-read)
NON-ACCESSED UPC
DELETE OF NON-ACCESSED UPC
(*) At this operation, the non-accessed UPCs data are printed and
deleted.
To stop the printing reports:
The printing of all reports can be stopped by the following operation.
Set the mode switch to "MGR" to cancel.
Note) When the printing is stopped, the consecutive number or Z
counter doesn't return to the original value.
For Z reports, Memory is not reset when canceled.
*1 X1: Daily X report Z1: Daily Z report
X2: Periodic X report Z2: Periodic Z report
OP X/Z X1/Z1
X Z X1 Z1
MGR/Flash-read: These reports are taken by the owner or manager
in order to check and display daily sales totals at
that point.
To print reports, use the following key entry sequence
Reading
JOB# @/FOR
Range is required
Resetting
MODE *1
X2/Z2 JOB# or KEY
X2 Z2 *3
00
09
09
01
07
07
10
12
13
20
21
27
27
29
30
31
50
51
60
60
70
80
81
90
DEPTn
[@/FOR]
[SBTL]
105
105(*)
105(*)
*2 The time interval range and PLU code range can be specified by
entering the start and end numbers according to the following
procedure. When specifying a single time interval or PLU code,
the start number has only to be entered.
XXXXXX
Start No.
*3 When 2 is entered in the third digit of a job code, periodic reports
are printed.
Example: Daily general report; job code 100
Periodic general report; job code 200
CA/AT
DATA FOR READING
NOTE
---
---
PICK UP *4
DEPT CODE
---
DEPT CODE
---
GROUP No.
---
PLU CODE *2
DEPT CODE
---
DEPT CODE
PRICE *2
---
---
---
---
---
TIME *2
---
PBLU CODE *2
---
--- *5
--- *5
--- *5
---
---
PICK UP *4
All
@/FOR
XXXXXX
End No.