Chapter 4. Op X/Z, X1/Z1, X2/Z2 Mode - Sharp ER-A520 Programming Manual

REPORT NAME
GLU/PBLU (SERVER)
CLOSE GLU/PBLU
CLOSE GLU/PBLU (SERVER)
STACK REPORT
NON ACCESSED UPC
NON ACCESSED
UPC DELETE (ALL)
NON ACCESSED
UPC DELETE (PICK UP)
JOB# : 'x' is 1 for X1/Z1 mode, 2 for X2/Z2 mode, and 0 or nothing for OPX/Z mode.
FLASH READING REPORT
REPORT NAME
DEPARTMENT
DEPARTMENT
CID
PAID TOTAL
* 1 MODE: X: Daily operator X report
X1: Daily X report
X2: Periodic X report
(X report) : The corresponding data is held in the ECR.
(Z report) : The corresponding data is cleared in the ECR.
* 2 To read respective reports, it is necessary to follow the procedure
below.
Reading
(X report)
JOB#
@/FOR
Resetting
(Z report)
* 3 To read respective reports, it is necessary to follow the procedure
below.
Reading
(X report)
JOB# @/FOR
Resetting
(Z report)
(DATA): GROUP No. (2 digit)
DEPT CODE (2 digit)
JOB# OPX/Z
X Z X1
o
x81
o
x82
o
x83
o
x90
o
x05
x05
x05
KEY ENTRY OPX/Z
X
[DPTn]
XX [DEPT#]
[X]
[SBTL]
Z: Daily operator Z report
Z1: Daily Z report
Z2: Periodic Z report
CA/AT
DATA CA/AT
ER-A 0/ER-A530 OP X/Z, X1/Z1, X2/Z2 MODE
MODE * 1
X1/Z1 X2/Z2
Z1 X2 Z2
o
o
o
o o o
o
o
MODE
X1/Z1 X2/Z2
Z X1 Z1 X2
o
o
o
o
* 4 The Report range can be specified by entering the starting and ending
numeric entries according to the following procedure.
Reading
JOB#
Resetting
(START NO.) and (END NO.): PLU CODE (6 digit)
* 5 Individual server/cashier report BILL NO. (4 digit) the assigned server/cashier.
* 6 When the server/cashier code is not entered, the report is issued only when
there is an assigned server. Otherwise a server code must be entered
to issue the report.
Reading
JOB#
Resetting
4 – 2
DATA FOR READING
SERVER CODE
BILL NO.
SERVER/CASHIER CODE
PICK UP
DATA FOR READING
Z2
XX = DEPT CODE (2 digit) * 9
@/FOR
All
Start = End
START NO. @/FOR END NO.
PRICE (6 digit)
TIME (2digit) (24-hour entry in spite
of TIME SYSTEM)
PBLU CODE (4 digit)
Assigned server/cashier
@/FOR SERVER CODE
4 digit
* 6
* 4
* 6
* 8
* 2
* 2
* 11
* 9
* 9
* 9
CA/AT
CA/AT