CHECKING OF THE FUEL LEVEL GAUGE.
Remove the fuel level gauge (19-10)
Measure the resistance between terminals.
The FLOAT position
F : 128.5[mm]
1/2 : 83.5[mm]
E : 28.5[mm]
The float position is based on the tank bottom plate after assemble.
Measure the resistance between Y/W (YELLOW/WHITE) wire and G(GROUND)
wire of fuel unit terminal
Remark : measuring unit of resistance : resistance[ ]
If the measured resistance value is out of standard at float position, replace the fuel unit.
EMS(Engine Management System)
Terminals resistance [ ]
40
5[ ]
220
5[ ]
400
3[ ]
5-35