Tires And Wheels; Tire & Wheel Inspection; Tire Pressure - DAELIM ET250 Owner's Manual

The filter should be replaced every 600 hours
of operation and at the start of each season.
To replace the filter, first turn the fuel valve to
the "ON" or "RES" position. Then carefully
compress the wire clamp rings until the clamp
is free of the fuel line. Slide each clamp away
from the filter about 3/4".
Remove the filter from the fuel line by holding
the line and pulling the filter. Install the new
filter by inserting the filter into the fuel line and
returning the clamps to the original position.
Turn the fuel valve to the "PRI" position and
check for leaks. Inspect the fuel lines for cuts,
abrasions and deterioration. Replace fuel lines
as needed. Return the fuel valve to the "ON"
position for normal operations.
DO NOT start or operate the engine if the fuel
filter or lines are leaking. Leaking fuel can
cause a fire.

TIRES AND WHEELS

TIRES AND WHEELS
Tire & Wheel inspection
It is important to inspect your tires and wheels
for damage and wear before each riding
session. Inspect each tire for cuts, tears and
punctures. Inspect the wheel rim for dents and
separation of the wheel from the tire bead.
CONTROL FEATURES CONTROL FEATURES
Inline Fuel Filter
Replace any tire or wheel found to be
damaged.
Operating your ATV with damaged tires or
wheels is dangerous. Damaged tires or wheels
can result in a sudden loss of tire pressure and
control which could result in injuries.
Check your tire pressure before each riding
session and at each refueling operation.
Always check the pressure when the tires are
cool. Use the tire pressure gauge that came
with your ATV to check the tire pressure.
Wheel Nuts torque 24-30 N/m (18-22 1b/ft)
¡¹

Tire Pressure