Table of Contents
Advertisement
Symptoms
No Device Found
No SCSI Interface Board Found or
No Response from SCSI Interface
Board
Possible Cause and Solution
Drive Not Resetting
In some cases, even if you restart the computer by pressing its reset button or the
Control, Alt and Del keys simultaneously, the drive does not appear to respond. Try
turning the power switches on the drive and computer OFF, then ON. This complete
shutdown should fully reset the drive and computer.
Symptom
CDR101 -- Not Ready
Reading Drive [X]
Possible Causes and Solutions
Defective Caddy
A warped or damaged caddy can cause a CDR 101 error message. Try using another
caddy and see if this eliminates the problem. Also, be sure to use only an ''industry
standard'' caddy. This is a caddy made of plastic with a metal shutter on its bottom.
If you use another type of caddy (e.g., all plastic, but with no metal shutter on its
bottom ---- just an opening), you may experience problems.
Defective CD-ROM Disc
A fingerprint or other contaminants or deep scratches on the disc's surface may prevent
the drive from reading data. Read Chapter 11 to learn how to clean CD-ROM discs.
You should also review the low performance symptom discussed on page 61.
CHAPTER 13 ---- Troubleshooting
Additional Symptom
Driver Fails to Recognize the SCSI
Interface Board
Additional Symptom
All Commands Sent to the Drive
Result in CDR101 Error
PX-63CS/PX65-CS OPERATION MANUAL
55
Advertisement
Table of Contents
