AdVANced SeTTINgS
Using Wi-Fi Protected Setup™
Belkin recommends that you set up WPA2 as your wireless security.
WPS does not provide additional security, but rather simplifies
the addition of wireless devices to your wireless network. You
may use either the Push Button Configuration (PBC) method or
PIN method to allow a device access to your wireless network.
PBc
Push and hold the WPS button located on the front of your
Range Extender for two seconds and the security LED will
flash, indicating that WPS has been initiated. Then, initiate
WPS on the client device within two minutes (refer to your
client's documentation on this procedure). The wireless
device and Range Extender will automatically exchange
a security key and establish a secure connection.
PIN
The client device has a WPS PIN number (eight digits) that will
be provided to you when you initiate the connection to the Range
Extender. Enable WPS through the screen illustrated to the
below. Enter the client's PIN into the Range Extender's internal
registrar (accessed through this screen). The client will be
securely enrolled into your wireless network within two minutes.
15