Table of Contents
Advertisement
VII. Hardware Information
VIP Connectors
VIP uses two dual row 0.1" center connectors — Connector A and Connector B.
Connector A is a 26-pin connector, which is the same as the standard Feature Con-
nector. Connector B is a 14-pin connector consisting of the power pins, ground,
VRST#, and I2S. On the master side, Connector A is male, and Connector B is
female. This applies to either the graphics adapter card or the motherboard. Slave
modules will have the opposite mating connectors. Connector B on the slave side
must be shrouded to prevent the danger of wrong insertion. Connector A can be
configured as a standard Feature Connector, VIP, or Connector A (video) of VMI
1.4. On power up, the graphics chip (master) is configured in the standard feature
connector mode. All VIP slaves must be disabled and tri-stated on power up.
VIP Module Mechanical Specification
22
26
Connector A-PT - 26 Pin Right Angle
Male (for Ribbon Cable Pass-thru)
25
VIP Module
(Component Side)
Shrouded Connector
14
Connector B
14 Pin Male
13
ASUS AGP-V3000 User's Manual
2
1
2
1
Advertisement
Table of Contents
