Setting - Ptz Config - TP-Link TL-SC3130G User Manual

Module Setting: Name the module device and ID that has been connecting the
digital input/output device(s) to your system.
Device: This column displays the device(s) already installed to the system.
ID: Select the number of the I/O port to which you plug the ribbon cable.
Input Monitor: The device(s) is turned on if the dot is in red. By triggering the digital
input device, the related icon will light up. This is used to check if the device is
correctly connected or not.
Output Monitor: The device(s) is turned on if the dot is in red. By clicking on the icon,
you may trigger the digital device connecting to the system. This can be used to test
if the output device is correctly connected.
Device Setting
Name: Insert the name of the device (input and output).
Type: Select the device type from the drop-down menu.
N/O: Normal Open.
N/C: Normal Close.

6.4 Setting - PTZ Config

Basic Setting
Advanced Setting
Install PTZ cameras following the instruction of the camera manufacturers. A PTZ
camera is usually connected to the PC with RS-485/RS-422.
Check the box on the camera list to activate the PTZ control function of a PTZ
camera.
Basic Setting: Select the camera model, com port, baud rate, and address
41