TP-Link TL-SC4171G Quick Installation Manual

Quick Installation Guide
Wireless Pan/Tilt Surveillance Camera
TL-SC4171G
MODEL NO.
3

Camera Mounting

Hollow anchors
NOTE: In the bracket, there are several mounting holes arranged in a circle. The direction of the camera's
installation can be anywhere within a 360 degree scope, adjusted as required.
It is strongly recommended that you connect the Ethernet cable and power adapter cord to the camera first
before mounting.
Bracket
Ceiling Mount
1 Fix the camera to the bracket
with two type A screws .
Fix the bracket and camera
2
to the ceiling using two
type B screws and two
hollow ceiling anchors.
7106503435

Package Contents

Camera Mounting Bracket Power Adapter
Quick Installation Guide
Wireless Pan/Tilt Surveillance Camera
MODEL NO. TL-SC4171G
Ethernet Cable Resource CD QIG
(*The pictures are for reference only.)
System Requirement
The following operating systems are supported:
• Windows XP • Windows Vista • Windows 7
• Windows 98 • Windows 2000 • Windows 2003
• Windows Me • Mac • Linux
The following browsers are supported:
• Microsoft Internet Explorer • FireFox
• Safari • Chrome
Type A screws Type B screws
Wall Mount
Fix the bracket to the wall
1
using two type B screws and
two hollow wall anchors.
Fix the camera to the bracket
2
with two type A screws .
1
Warning Before Installation
• Do not keep the
Camera exposed to
direct sunlight.
• Do not place the
Camera in high humidity
environments such as
in a kitchen.
• Do not place the
Camera where there are
sharp temperatures such as
near an oven.
• Do not place the camera
near devices that emit
radio waves, such as
mobile phones.
4

Hardware Connection

12V DC Audio in Audio out Ethernet
I/O
reset
Power Cable
2
Physical Description
Antenna Connector
Audio Out
Power Connector
Network Connector
General I/O Terminal Block
12V DC Audio in Audio out Ethernet
I/O
reset
Reset Button
Audio In
Built-in Microphone
Power LED
Ethernet LED
Item
D escription
• Solid: The electrical power is on.
Power LED
t
• Off: There is no electrical power.
• Solid: The Ethernet port is linked, but there is no activity.
• Blinking: There is traffic between the Ethernet port and
Ethernet LED
the network.
• Off: There is no Ethernet connection.
• Step 1: Re-power on the camera and wait for at least 45s
Reset Button
until it restarts up normally.
• Step 2: Press the button for more than 10s, then it will be
restored to factory defaults after automatic rebooting.
NOTE: Before proceeding, confirm that your PC is connected
to your router and can access the Internet. Also confirm that
your router's DHCP feature is enabled. (Most routers have
DHCP turned on by default.) For detailed information, please
refer to the operation instructions included with your router.
Internet
1 2 3
WAN LAN
Router
Ethernet Cable