Dell PowerEdge 2410 Manual page 3

5 Install the coupling brackets.
Position the two racks side by side.
a
Adjust the leveling feet on both racks so that the racks are parallel and in
b
the same horizontal plane. For instructions, see "Adjusting the Leveling
Feet" in your rack installation guide.
Install the four coupling brackets on the racks (two on the top and two
c
on the bottom) as shown in Figure 1-3.
Hook the brackets into the square holes inside and adjacent to the rack
posts, and tighten the brackets using the wing nuts (see Figure 1-3).
Figure 1-3. Coupling Two Racks
3
2
1 coupling bracket locations
3 coupling bracket (4)
1
2 wing nut