Dell PowerEdge 1950 Information Update page 11

Table 1-1. System Messages
Message
Alert! Node
Interleaving
disabled! Memory
configuration does
not support Node
Interleaving.
!!*** Error: Remote
Access Controller
initialization
failure *** RAC
virtual USB devices
may not be
available...
Invalid PCIe card
found in the
Internal_Storage
slot!
No boot device
available
Causes
The memory configuration
does not support node
interleaving, or the
configuration has changed
(for example, a failed
DIMM) so that node
interleaving cannot be
supported. The system
runs but with reduced
functionality.
Remote Access Controller
initialization failure.
The system halted because
an invalid PCIe expansion
card is installed in the
dedicated storage
controller slot.
Faulty or missing optical
drive subsystem, hard
drive, or hard-drive
subsystem, or no bootable
USB key installed.
Corrective Actions
Ensure that the memory
modules are installed in a
configuration that supports
node interleaving. Check
other system messages for
additional information
for possible causes. For
memory configuration
information, see "General
Memory Module
Installation Guidelines"
in the Hardware Owner's
Manual. If the problem
persists, see
"Troubleshooting System
Memory" in the Hardware
Owner's Manual.
Ensure that the Remote
Access Controller is
properly installed. See
"Installing a RAC Card"
in the Hardware Owner's
Manual.
Remove the PCIe
expansion card and install
the internal SAS controller
in the dedicated slot.
Use a bootable USB key,
CD, or hard drive. See
"Using the System Setup
Program" in the Hardware
Owner's Manual for
information on setting
the order of boot devices.
Information Update
11