Installing External Storage
Devices
Optional mass storage devices can be connected to the server by using the
external SCSI connector on the back of the unit, or by using an optional Wide-
Ultra SCSI-3 Controller board. To install an external storage device to the
external SCSI connector, refer to the installation documentation that came
with the external storage device. Also, see Chapter 4, "SCSI Cabling
Instructions for Mass Storage SCSI Devices," for additional cabling
information. The following illustration provides only an overview of this
installation.
Figure 3-19. Connecting external mass storage device
Compaq ProLiant 800 Servers Supporting Pentium II Processors and 100-MHz System Bus Setup and Installation
timber-23 .EPS
3-23
Guide