Configuring Qlogic Hbas; Installing From The Re-Install Cd-Rom - HP Integrity BL890c - i2 Server Software Manual

Fibre channel host bus adapters software guide for windows

Hide thumbs Also See for Integrity BL890c - i2 Server:

Manual (229 pages)

Software manual (37 pages)

Quickspecs (34 pages)

Table Of Contents

Table of Contents

15.

Select Configure Boot Devices.

NOTE:

If there is an entry in the boot table, press Enter and then select Clear Flash Boot Info. This

creates an empty table. Continue with the procedure.

16.

Select Scan Targets to return to the empty Boot Table screen.

The HBA is now logged into the switch.

17.

Follow the steps in

18.

On the boot server, select the first line and then press Enter.

19.

Select Scan Targets.

A single WWN appears. This is the node to which your boot device is attached.

20.

Using a storage configuration application, or following the procedures in from

LUN, create one LUN and give it access to the HBA WWN.

NOTE:

For Disk Array XP, you must run Scan Targets a second time after you create LUN 0 and

present it to the host. Doing so makes the WWNN of the boot HBA available so it can be

presented to the LUN.

21.

On the boot server, press Enter to display a LUN. (This is the LUN to which your boot device has

access.) Press Enter.

22.

Select Boot this device via WWN.

The boot table has one entry that displays the boot device target WWN and LUN information.

23.

Press ESC until you exit the utility.