Advertisement
Quick Links
This document is an addendum to the Camera Housing Operating Instructions and
describes how to connect power to a Axis network camera installed in the housing. Please
read through both instructions before proceeding with the installation.
This description applies to the following articles:
Product
•
Verso Cool Outdoor Housing, HPV42K0A017
•
VT Outdoor Power Supply OHEGBPS1B
•
VT Heater 110/230VAC OHPVH1
•
230V cable
•
12V cable
•
AXIS 210/210A/211/211A
•
AXIS 221
High voltage - the apparatus works on 230V AC. Always ensure that the power is discon-
nected before starting any work or opening the housing.
This product should be installed by certified electrical technicians in compliance with local
laws and regulations.
Use cable glands and/or cables that are suitable for external use and are in compliance with
local laws and regulations.
Installation Instructions
Description
Housing
Power supply
Heater
Power cable
Power cable (min. area 0.5mm
Network Camera
Network Camera
Important!
Part number
0217-141
0217-151
0217-161
not supplied
2
) not supplied
Advertisement
Related Manuals for Axis 25254
Summary of Contents for Axis 25254
- Page 1 Installation Instructions This document is an addendum to the Camera Housing Operating Instructions and describes how to connect power to a Axis network camera installed in the housing. Please read through both instructions before proceeding with the installation. This description applies to the following articles:...
- Page 2 Installation Instructions Power supply connectors Mains power cable 12V power cable to housing/camera Housing connectors Camera connectors (8) AXIS 210/210A/211/211A AXIS 221 (+)(-) (-)(+)
- Page 3 Installation Instructions Powering the Axis network camera, housing and heater Note - this installation requires 2 x 230V power cables and 2 x 12V cables (not supplied). 1. Pull the mains power cable through the gland (5) to the housing connector (J4).
- Page 4 Installation Instructions Powering the Axis network camera and housing (no heater) Note - this installation requires one 230V power cable and 2 x 12V cables (not supplied). 1. Connect the mains power cable to the connector (A) in the power supply.