Table of Contents
Advertisement
CONNECT TO
THROTTLE LINKAGE
091-84-VA
Stroke adjust
SOURCE
091-84-VV
SOLENOID
AIR VALVE
NOTE:
Some engines have one
side of starter solenoid at
ground and the neutral
safety switch in the supply
side.
These must have a diode
installed across the starter
solenoid as illustrated.
This is particularly true of
FORD products
FOR ENGINES WITH NEUTRAL SAFETY SWITCH CONNECTED TO STARTER
CHAIN,
VACUUM
ACTUATOR
KUSSMAUL
OFF
ENGINE IDLER
VOLTAGE MONITOR & ENGINE IDLER
INSTALLATION AND WIRING DIAGRAM
BRAKE SWITCH
BATTERY +
Starter
Solenoid
SEE NOTE:
Connect 1N4004
as shown to suppress
starter solenoid transient
ON
HIGH
VOLTAGE MONITOR
Figure 4
BRAKE
LIGHT
DIODE
On some vehicles install diode to
prevent emergency flasher or
turn signals from turning off the
engine idler
+12 volts from ignition switch
in "START" position
NEUTRAL
SAFETY SWITCH
CLOSED IN NEUTRAL OR PARK
1 amp fuse
To +12 volts
thru accessory
position of
Ignition switch
KUSSMAUL
LOW
Advertisement
Table of Contents
