Page 1
BOOK# 091-9-090 inst.book Aug. 3, 2005 INSTRUCTION MANUAL AUTO DRAIN ACHP AN AUTOMATIC MOISTURE DRAIN FOR THE 091-9HP AIR COMPRESSOR MODEL #091-9-090 INPUT :120 Volt, AC Solenoid 1 YEAR WARRANTY KUSSMAUL ELECTRONICS CO., INC 170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796...
Page 2
INTRODUCTION The Auto Drain ACHP system consists of a 120 volt normally open solenoid, a filter and assorted fittings. Designed to work with the 120 volt Model 091-9HP Auto Pump, the solenoid bleeds the filter bowl when the pump is not running. As soon as the pressure switch turns on the compressor, the solenoid is energized and the bleed is closed.
Page 3
091-9-090 AUTO DRAIN ACHP INSTALLED ON 091-9HP AUTO PUMP...
Page 4
AUTO DRAIN WIRING INSTALLATION 1. Install the black sleeving over the solenoid wires 2. Connect the AUTO DRAIN solenoid wires to output terminals of pressure switch. These are the same terminals that supply power to the AUTO PUMP motor 3. The AUTO DRAIN is now properly connected. Test by bleeding system pressure to start AUTO PUMP and note that when pump shuts down, air and moisture will bleed out of drain tube.
Page 5
Vehicle Identification Vehicle Owner All Auto Pumps of Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 1 year from the date the equipment was shipped.
Need help?
Do you have a question about the 091-9-090 and is the answer not in the manual?
Questions and answers