Page 1
BOOK# 091-9-086 inst.book Aug. 3, 2005 INSTRUCTION MANUAL AUTO DRAIN AN AUTOMATIC MOISTURE DRAIN FOR THE 091-9 AIR COMPRESSOR MODEL #091-9-086 INPUT :12Volt, Solenoid 1 YEAR WARRANTY KUSSMAUL ELECTRONICS CO., INC 170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796 TEL: in NY 631-567-0314...
Page 2
INTRODUCTION The Auto Drain system consists of a 12 volt normally open solenoid, a filter and assorted fittings. Designed to work with the 12 volt Auto Pump, the solenoid bleeds the filter bowl when the pump is not running. As soon as the pressure switch turns on the compressor, the solenoid is energized and the bleed is closed.
Page 3
091-9-086 AUTO DRAIN INSTALLED ON 091-9 AUTO PUMP Note: 1. Install pressure switch on Auto Drain before installing Auto Drain on pump. It may be necessary to slightly rotate solenoid valve to clear pressure switch when installing.
Page 4
AUTO DRAIN WIRING INSTALLATION 1. Install the black sleeving over the solenoid wires 2. Connect the AUTO DRAIN solenoid wires to output terminals of pressure switch. These are the same terminals that supply power to the AUTO PUMP motor 3. The AUTO DRAIN is now properly connected. Test by bleeding system pressure to start AUTO PUMP and note that when pump shuts down, air and moisture will bleed out of drain tube.
Page 5
Vehicle Identification Vehicle Owner All Auto Pumps of Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 1 year from the date the equipment was shipped.
Need help?
Do you have a question about the 091-9-086 and is the answer not in the manual?
Questions and answers