1. Manuals
  2. Brands
  3. KUSSMAUL Manuals
  4. Monitor
  5. 091-84-005
  6. Instruction manual

KUSSMAUL 091-84-DS Instruction Manual

Engine idler module
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Table of Contents

FILE: 091-84.P65 date: 06-02-99
INSTRUCTION MANUAL
ENGINE IDLER MODULE
PART OF A HIGH IDLE SYSTEM
ENGINE IDLER
MODEL #091-84-005
VOLTGAE MONITOR
MODEL #091-84-004
3 YEAR WARRANTY
.
KUSSMAUL ELECTRONICS CO., INC
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796
TEL: in NY 631-567-0314
TOLL FREE: 800-346-0857
FAX: 631-567-5826

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 091-84-DS and is the answer not in the manual?

Questions and answers

Related Manuals for KUSSMAUL 091-84-DS

Summary of Contents for KUSSMAUL 091-84-DS

  • Page 1 ENGINE IDLER MODULE PART OF A HIGH IDLE SYSTEM ENGINE IDLER MODEL #091-84-005 VOLTGAE MONITOR MODEL #091-84-004 3 YEAR WARRANTY KUSSMAUL ELECTRONICS CO., INC 170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826...
  • Page 2 INTRODUCTION The High Idle System consists of a model 091-84-005 Engine Idler and a model 091-84-004 Voltage Monitor. The system permits a vehicle operator to increase engine RPM to obtain more alternator output. RPM may be increased manually from the Engine Idler or automati- cally from the Voltage Monitor when the system voltage drops below the threshold.
  • Page 3 INSTALLATION Typical installations on gasoline and diesel engines are illustrated in figures 1 and 2. Mount actuator and solenoid valve in an appropriate location and connect the actuator output to the throttle mechanism. (Note: The actuator and solenoid valve must be purchased seperately. Be certain that the ball chain or other coupling does not restrict throttle motion at full closed throttle or wide-open throttle.

  • Page 4: Test Procedure

    TEST PROCEDURE 1. With the transmission switch in PARK turn the ignition switch the Accessory position. The LED on the Engine Idler should remain OFF. 2. Press the "ON" switch on the Engine Idler. The LED on the Engine Idler should turn 3.
  • Page 5 CAUTION FORD INSTALLATIONS FORD, in many installations uses a starter solenoid which has one side of the coil grounded. The neutral safety switch is then placed in the supply side of the solenoid coil. This configuration creates a considerable voltage spike when the vehicle is started. A diode must be placed across the starter solenoid in these installations to prevent dam- age to the engine idler.
  • Page 6 091-84-PV 1 amp fuse To +12 volts thru accessory position of Ignition switch SOLENOID AIR VALVE KUSSMAUL KUSSMAUL HIGH ENGINE IDLER VOLTAGE MONITOR VOLTAGE MONITOR & ENGINE IDLER INSTALLATION AND WIRING DIAGRAM FOR DIESEL ENGINES WITH AIR PRESSURE AVAILABLE Figure 2...
  • Page 7 Kussmaul Electronics Company, Inc. shall have no liability for dam- ages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. products. The pur- chaser, by the acceptance of the equipment, assumes all liability for any...

This manual is also suitable for:

091-84-dsp091-84-005091-84-004

Table of Contents