Installing The Water Dispenser Line - Samsung RF260BEAEWW User Manual

INSTALLING ThE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator. To help promote
better health, the water filter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a
water pressure of 20~125psi ( 138~862kPa) is
required.
Under normal conditions, a 170 cc (5.75 oz.) cup
can be filled in about 10 seconds.
If the refrigerator is installed in an area with low
water pressure (below 20psi), you can install
a booster pump to compensate for the low
pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly filled. To do this, press the water
dispenser lever until the water runs from the water
outlet.
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and ¼" compression nut.
Connecting to the water supply line
1.
First, shut off the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
cold water line
Shut off valve
10_ setting up
DA68-02601B(EN+ES+FR)-0.0.indb 10
Pipe clamp
3.
Connect the water line installation kit to the
shut off valve.
cold water line
Pipe clamp
Shut off valve
Connecting the water supply line to
the refrigerator.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
use copper tubing use Plastic tubing
• ¼" copper tubing •
• ¼" compression nut (1pc)
• Ferrule (2pc) •
Refrigerator
Compression
Nut (1/4")
(Assembled)
Ferrule
(Not supplied)
Copper tubing
or
(Not supplied)
household water supply line
1. Connect the household water line to the
assembled compression fitting.
- If you are using copper tubing, slip the
compression nut ( B ) (not supplied) and
ferrule (not supplied) on the copper tubing (not
supplied) as shown.
- If you are using plastic tubing (
molded end (Bulb) of the plastic tubing ( B )
into the compression fitting.
Water line installation kit
¼" plastic tubing
→ Molded end(Bulb)
¼" compression nut (1pc)
Plastic Tubing
(Assembled)
Compression
Fitting
(Assembled)
Molded
end(Bulb)
Compression
nut (B) (1/4")
(Not supplied)
Plastic tubing (B)
(Not supplied)
B ) , insert the
2012.3.29 9:28:42 AM