Door And Drawer Removal - Maytag MFD2561HE - 36" Bottom-Freezer Refrigerator Use & Care Manual

Installation
I Note I
• Some models only have adjustment screws "A"
4. Using the hex head driver, turn each of these
adjustment screws (B) to raise or lower the rear of
the refrigerator.
5. Using the carpenter's level, make sure front of
refrigerator is '/," (6 mm) or ½ bubble higher than
back of refrigerator and that the refrigerator is level
from side to side.
6. Turn stabilizing legs (C) clockwise until firmly
against floor.
7. (urn adjustment screws (A) counterclockwise to
allow the full weight of the refrigerator to rest on
the stabilizing legs.
8. Replace hinge cover(s).
• Position cover into the outer edge of the hinge.
• Swing the cover toward the cabinet and snap it
into place.
9. Replace the toe grille.
I Note
• For proper reinstallation, ensure the "top" marking
on the interior of the toe grille is oriented correctly.
• Align the toe grille mounting clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.
Door and Drawer Removal
Some installations require door/drawer removal to
transport the refrigerator to its final location.
.
2.
.
4.
.
.
7.
.
.
Unplug power cord from power source.
Remove toe grille and bottom hinge
cover(s) (see page 3).
Remove top hinge cover from
refrigerator door by removing Phillips
screw and retain screw and cover for
later use.
Unscrew Y,," hex head screws from
top hinge to remove hinge and retain
all screws for later use.
Lift fight side refrigerator door from " ".
center hinge pin. Remove door
closure from center hinge pin on
the right side and retain for later
use.
Disconnect wire hamess on top
of left side refrigerator door top
hinge.
Release two-pin connector by
pressing junction point with a
flat blade screwdriver or
fingernail
Green ground wire remains
attached to the hinge.
Unscrew _8" hex head screws from
top hinge to remove hinge and retain
for later use.
Lift left side refrigerator door, along
with top hinge, from center hinge pin.
Remove center hinge pin with a '/,6"
hex head driver and retain hinge pin
for later use.
Remove Phillips screws to remove
right and left hinges and retain all
screws for later use.
Remove both stabilizing brackets
with %"hex head driver and retain
screws for later use.
_-_ right
s=de
door
closure
N