Table of Contents
Advertisement
installation
Your refrigerator
was packed carefully
for shipment.
Remove and discard shelf packaging
and tape. Do not
remove the serial plate.
Leveling
Location
• Do not install refrigerator
near oven, radiator or other
heat source. If not possible, shield refrigerator
with
cabinet material.
• Do not install where temperature falls below 55 ° F
03 ° C_)or rises above 110 ° F {43 ° C). Malfunction
may
occur at this temperature,
• Refrigerator
is designed
for indoor household
application
only.
Measuring the Opening
When installing your refrigerator,
measure carefully.
Allow ½" space at top and Yz"space behind the machine
compartment
cover (located in the rear} for proper air
circulation.
Subfloodng
or floor coverings
0.e. carpet, tile, wood
floors, rugs) may make your opening
smaller than
anticipated.
Some clearance may be gained by using the leveling
procedure
under Leveling.
_mportant:
If refrigerator
is to be installed
into a recess
where the top of the refrigerator
is completely
covered,
use distance from floor to top of hinge cap to verify
proper clearance.
Transporting Your Refrigerator
• NEVER transport
refrigerator
on its side. if an upright
position is not possible, lay refrigerator
on its back.
Allow refrigerator
to sit upright for approximately 30
minutes before plugging it in to assure oil returns to
the compressor. Plugging the refrigerator
in
immediately may cause damage to internal parts.
• Use an appliance dolly when moving refrigerator.
P,I.WP,YS truck refrigerator
from its side or
back-NEVER
from its front.
• Protect outside finish of refrigerator
during transport
by wrapping
cabinet in blankets
or inserting
padding
between the refrigerator
and dolly.
• Secure refrigerator
to dolly firmly with straps or
bungee cords. Thread straps through handles when
possible. Do not overtighten.
Overtightening
restraints
may dent or damage outside finish.
To enhance
the appearance
and maintain performance,
the refrigerator
should be level.
Note
• Complete
any required door reversal, panel
installation
and/or a water supply connection,
before
leyeling.
Materials
Needed:
• %" hex head driver
• Carpenter's
level
1. Remove toe grille.
• Grasp firmly and pull outward
to unclip.
2. Remove bottom hinge cover{s).
.
• Place the eraser end of a pencil or similar blunt
tool in the cover notch.
!!_!_i¸¸_
i! _
Location
• Use slight pressure to pry the
cover loose.
• Continue to maintain
downward
pressure to the
notched side of the cover while
swinging
it off.
Using hex head driver, turn the front adjustment
screws CA} on each side to raise or lower the front
of the refrigerator.
C
C
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
