Kenmore 7531 - 22.0 cu. Ft. Top Freezer Refrigerator Use & Care Manual page 15

• Loosen the2 screws andremove thedoor
Closer/Stop.
Fig.41
_ Door Closer/Stop
, With a flat-head screwdriver, carefully pry off and
remove the cover over the screw holes on the left side
of refrigerator housing.
Fig. 45
Take Door Closer/Stop and flip it over. Line up screw
holes and screw it into left side of door bottom.
Turn door upright. It is now ready for re-attaching.
Fig. 42
, Insert the water dispenser tube into the left channel at the
base of the dispenser cavity until it comes out of the bottom
left corner of door.
° Insert and reattach tube guide.
Fig. 43
e u d e screw
left channel right channel "_ _J
o Reconnect the wire connector to the back of the dispenser
cover, then insert the dispenser cover top clips into the
slots in the top of the dispenser cavity. Make sure that the
dispenser tube is lined up with the hole in the dispenser
cover. Press against cover firmly to reattach.
Fig. 44
15
• Remove the outer screw from cabinet at area
between freezer and refrigerator doors.
(You will need this hole for the Middle Hinge Bracket.)
Fig. 46
0
- Place screw into outer hole on right side of cabinet.
Attach cover on the right side. Cover is force-tilted.
S._ew
• Flip the middle hinge bracket (flange now will be on
top) and position on left side of refrigerator and
re-attach with two bolts and a phillips screw.
Fig. 48
Middle ge
Bracket
Pull the wire harness out from the base as shown
below.
Fig. 49