Section Six: Care And Maintenance - Thermador PRL366EH Care And Use Manual

Use and care guide
Hide thumbs Also See for PRL366EH:
Table of Contents

Advertisement

Available languages

Available languages

SECTION
SIX: CARE AND MAINTENANCE
Cleaning Recommendations
Part/Material
Front
Frame
Stainless
Steel
Oven Racks and Rack Guides
Nickel Plated
NOTE:
The rack guides are removable,
for cleaning
using this procedure
(see removel instructions
below).
Exterior,
Frame,
Handle,
Heat
Deflector
Stainless
Steel
Cleaning
Products/Directions
See Cooktop,
Back Guard,
Page 30.
Hot sudsy
water.
Wash,
rinse thoroughly,
and dry.
Cleaners:
Soft Scrub ®.
Apply with a damp sponge
or cloth according
to manufacturer's
directions.
Rinse and wipe dry.
Powdered
Cleanser:
Bon-ami ®, Comet ®, Ajax ®.
Apply with a damp sponge
or cloth according
to manufacturer's
directions.
Rub lightly.
Rinse thoroughly
and wipe dry.
Soap filled
fiber
or steel wool
pads:
S.O.S ®, Brillo ®.
Dampen
pad, rinse thoroughly,
and dry.
Harsh
Cleaners:
Easy Off ®Oven Cleaner.
NOTE: Some
commercial
oven
cleaners
cause
darkening
and
discoloration.
Test the cleaner
on a small part of the rack and
check for discoloration
before cleaning
the entire
rack.
Apply a generous
coating.
Allow to stand for 10 to 15 minutes.
Rinse thoroughly
and wipe dry.
If the racks do not slide easily after being cleaned,
dampen
a paper
towel with a small amount of cooking oil and rub it lightly over the side
rails.
Use care to keep cleaners
and water awayfrom
the door vents.
If water
or cleaners
spill into the vents, water may streak the glass inside.
See Cooktop,
Back Panel, Stainless
Steel, Page 30.
Interior
See Oven Cavity,
Page 32.
Porcelain
Enamel
Seal
General
Kitchen Cleaners:
Formula
409% Fantastik ®.
DoorGasket
Spray on and blot dry with a cloth. Donotrub.
Donotmove,
remove
or damage
mesh.
Rack Guide
removal,
for cleaning:
1.
Lift the front of rack guide to clear the heads of the two
shoulder
bolts at the front of the oven cavitiy.
2.
Remove
the front portion of the rack guide by pulling the
guide's
key slots over the shoulder
bolts.
3.
Pull the two rails out of the holes in the back of the oven
cavity.
Note: The rack guides are designed
to fit either side of the oven
cavity.
33

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents