Page 1
GAS HOB MGH 620 INSTRUCTION BOOKLET Please read this instruction booklet before using the appliance Keep this instruction book for future reference and ensure it is passed on to any new owner. 1. Hob Top 2. Rapid Burner 3. Semi-rapid Burners 4.
Important Safety Information You MUST read these warnings carefully before installing or using the oven. If you need assistance, contact our Customer Care Department on 08705 950950 Installation When using other electrical appliances, ensure the cable does not come into contact This hob must be installed by qualified with the hot surfaces of the cooking appliance.
Maintenance Operation and Cleaning Hob Burners Before any maintenance or cleaning To light a burner: can be carried out, you must push the electric ignition push button which DISCONNECT the hob from the is marked by a little spark ( electricity supply.
Service and Spare Parts Guarantee Conditions We, Moffat, undertake that if, within 12 months of the date of the purchase, this Moffat appliance or any part thereof is proved to be defective by any reason only of faulty workmanship or...
Important safety requirements This hob must be installed in accordance with FITTING THE GAS HOB the Gas Safety (Installation and Use) WITHOUT A COOKER HOOD ABOVE Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). Detailed recommendations are contained in the following British Standards Codes Of 700 mm Practice: B.S.
When the hob is first installed Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory. On the end of the shaft, which includes the FO 0814 GJ 1/2" threaded elbow, adjustment is fixed so that the washer is fitted between the components as shown in the diagram.
Building In ON/OFF SWITCH ON/OFF SWITCH Building over a cupboard or drawer FLEX OUTLET FLEX If the hob is to be installed above a cupboard OUTLET or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface.
Electrical connections Permanent Connection Any electrical work required to install this hob should be carried out by a In the case of a permanent connection, it is qualified electrician or competent necessary that you install a double pole switch person, in accordance with the current between the hob and the electricity supply regulations.
Wiring Diagram A. IGNITOR SWITCH B. IGNITOR UNIT 220/240 Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. 1. Turn the gas tap to the MAX position and ignite.
Pressure Testing 1. Remove left hand pan support and front left burner cap and crown. 2. Fit manometer tube over the injector. 3. Turn on the burner gas supply and ignite another burner. 4. The pressure reading should be nominally 20mbar and must be between 17 mbar and 25mbar.
Page 12
Characteristics of gas burners BURNER RAPID SEMI-RAPID AUXILIARY (large) (medium) (small) TYPE OF Characteristics POSITION NOMINAL THERMAL 0.65 0.45 0.33 NATURAL POWER (kW) NOMINAL FLOW 0.286 0.062 0.190 0.043 0.095 0.031 20 mbar RATE (m NOZZLE REFERENCE Adjust. Adjust. Adjust. (1/100 mm) NOMINAL THERMAL 0.65...
Need help?
Do you have a question about the MGH620B and is the answer not in the manual?
Questions and answers