Install The Ap-60 - Epson AP-60 - Projector Sound Solution Installation Manual

Install the AP-60

Locate the following parts:
• AP-60
• Lower bracket
• M47.5 jam nut
• M10 bolt and nut
1 Locate the lower bracket and M47.5 jam nut and have them close by.
2 Before attaching the AP-60 to the mounting pipe, feed the projector's power and video cables through the
cable channel as shown below.
3 Slide the AP-60 and the lower bracket onto the mounting pipe with the audio control panel facing the front
of the room. The lower bracket's cutout should line up with the cable channel on the bottom of the AP-60.
4 Secure the lower bracket with the M47.5 jam nut as shown below. Do not attach the M10 bolt and nut at
this time.
Lower bracket
cutout
Lower bracket
M47.5 jam nut
14