Planning The Installation - Epson AP-60 - Projector Sound Solution Installation Manual

Planning the Installation

Here are the basic steps required to install the AP-60. Allow at least 1 to 2 hours to complete the installation. Be
sure to read all of the installation instructions before starting.
Note
Epson strongly recommends that the AP-60 be installed by a professional audio/video installer or other qualified
professional. Epson cannot provide advice concerning construction practices or building codes in your area.
The Installation requires at least two people.
For added safety, install the included guy wires to prevent the AP-60 from falling. Ensure that the ceiling is strong enough
before installing the wires.
2
Install the mounting pipe. See page 13.
4
Install projector and connect cables.
See page 19.
1
Install the IR dome sensor. See page 11.
10
3
Install the AP-60 and connect cables.
See page 14.
5
Adjust the sound. See page 21.