Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - MANAGING SENSOR DEVICES REV 1 Manual page 19

If you have selected SDEE:
Step 10
Click Configure.
a
The SDEE Configuration Parameters window appears.
Enter values for the following parameters:
b
- URL - Specify the URL required to access the device, for example,
https://www.mysdeeserver.com/cgi-bin/sdee-server. You must use an http or
https URL.
If you are using RDEP (for Cisco IDS v4.0), the URL should have
/cgi-bin/event-server at the end. For example:
https://www.my-rdep-server.com/cgi-bin/event-server
If you are using SDEE/CIDEE (for Cisco IDS v5.x and above), the URL
should have /cgi-bin/sdee-server at the end. For example:
https://www.my-sdee-server/cgi-bin/sdee-server
- Username - Specify the user name. This username must match the SDEE
URL username used to access the SDEE URL.
- Password - Specify the user password. This password must match the
SDEE URL password used to access the SDEE URL.
- Max Events Per Query - Specify the maximum number of events to retrieve
per query. The default is 100.
- Severity Filter - Select the check boxes you wish to use to configure the
severity level. A sensor devices that supports SDEE returns only the events
that match this severity level. Options include: Low, Medium, and High. By
default, all check boxes are selected. You must have at least one check box
selected.
- Force Subscription - Select the check box if you wish to enforce this
connection. Select yes to force the server to drop it's least active connection
to accept this connection; select no if you wish to not force this connection.
By default, the check box is selected.
Click Save.
c
Managing Sensor Devices Guide
Configuring Protocols 15