Enter values for the parameters:
b
- IP or Hostname - Specify the IP address or hostname of the Juniper NSM
server.
- Inbound Port - Specify the port to which the Juniper NSM sends
communications.
- Redirection Listen Port - Specifies the port to which traffic is forwarded.
- Use NSM Address for Event Source - Select the check box if you wish to
use the Juniper NSM server's IP address instead of the managed device's
IP address for an event source. If you do not wish to use the Juniper NSM
server's address, you must create a separate sensor device for each device
managed by the NSM.
Click Save.
c
The Protocol Configurations window appears.
If you selected LEA:
Step 9
Click Configure.
a
The LEA Configuration Parameters window appears.
Managing Sensor Devices Guide
Configuring Protocols
13