Arming Diagnostics; Disarming Diagnostics - Directed Electronics 2000 Owner's Manual

Directed electronics model 2000 alarm system owner's guide

Hide thumbs Also See for 2000:

Table of Contents

Arming Diagnostics

If the system is armed while an input is active (e.g. sensor trig-

gering) the unit will chirp once when arming and then one more

time a few seconds later. This is called Bypass Notification.

The security system will ignore the input that was active when the

system was armed, until the input goes away. Three seconds later

the system will monitor that input normally. For example, if the

tilt switch (motorcycles only) is at an unusual angle, and you try

to arm the system, you may hear Bypass Notification chirps. Once

the tilt switch is restored to its proper angle, the vehicle will be

monitored normally.

NOTE: Bypass Notification will not occur if the chirps have been pro-

grammed OFF.

Extra disarm chirps are the Tamper Alert. If four chirps are heard

when disarming, the security system was triggered in your

absence. If five chirps are heard, a zone was triggered so many

times that Nuisance Prevention

In either case, the status LED will indicate which zone was

involved (see Table of Zones section). The system will retain this

information in its memory, and continue to chirp four or five times

each time it is disarmed, until the next time the ignition key is

turned on.

2001 Directed Electronics, Inc.

Circuitry has bypassed that zone.

Table of Contents