Disarming Without A 2-Way Remote - Directed Electronics Clifford 120XV User Manual

NOTES: The first press of the remote button, while the remote is
beeping, only clears the alarm page (no command is sent to the
vehicle).
The transceiver transmits immediately upon system trigger and
does not allow disarm during the first 6 seconds after trigger.
The 2-way remote will respond with a number of beeps and LED
flashes according to whether a pinswitch, sensor, activated the
alarm (and also if NPC is active).
➜

disarming without a 2-way remote

This feature allows you to disarm the security system without the 2-way
remote should it be lost, damaged, or disabled. In order to disarm the
system without a 2-way remote, you must have the vehicle's ignition key
and know where the Valet
installer for the location and the number of presses of the Valet
required to disarm the system.
To disarm the security system,turn the ignition to the ON posi-
tion.
Press the Valet
five times) within 15 seconds. After five seconds the system
will disarm. If the system does not disarm, you may have
DRW-35
waited too long; turn the ignition Off and On and try again.
Location of Valet
Number of Pulses______________________________________
16
® button is located. Be sure to check with the
® button the preset number of times (one to
® Button_________________________________
®
© 2004 directed electronics, inc.
button