Table of Contents
Advertisement
Valet
®
Mode
You can prevent your security system from automatically arming
and triggering by using Valet
washing or servicing the vehicle. In Valet Mode, the security sys-
tem will not arm, even with the remote transmitter, but all con-
venience functions will continue to operate normally.
To enter or exit Valet
®
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet
switch within 10 seconds.
The status LED will light solidly if you are entering Valet Mode, and
it will go out if you are exiting Valet Mode.
Nuisance Prevention
Your system has DEI
®
prevents annoying repetitive trigger sequences due to faulty sen-
sors or environmental conditions such as thunder, jackhammers,
airport noise, etc. Here's how it works:
The alarm triggers three times. Each time, the same shock sensor
or switch is triggering the alarm. The three triggers are within 60
minutes of each other. NPC will interpret this pattern of triggers
as false alarms. After the third trigger, NPC ignores, or bypasses,
2001 Directed Electronics, Inc.
©
®
Mode. This is very useful when
Mode with the Valet switch:
®
Circuitry
's Nuisance Prevention
DRW-35
®
Circuitry (NPC
®
). It
11
Advertisement
Table of Contents
