Novell Netware 6.X - D-Link DGE-560T - Gigabit PCI-Express SNMP VLAN Flow Control Network Adapter User Manual

10. Select SELECT MODIFY DRIVER PARAMETERS/PROTOCOLS.
11. Configure the protocols to be used.
12. Configure the parameters, e.g. "slot number".
13. After the parameters have been configured, select SAVE PARAMETERS AND LOAD DRIVER.
The driver is loaded.
14. If desired, change the network adapter parameters or bindings in the autoexec.ncf file using the "Nwconfig" tool.
To install the network driver on Novell NetWare 6.x, proceed as follows:
1. After you have installed the network adapter in your computer, boot your NetWare system. NetWare detects the new
network adapter and tries to install a driver.
2. To get a list of available drivers, press <Enter>.
3. The menu "Select a driver" is displayed.
4. To install an unlisted driver, press <Insert> (the D-Link driver is not listed).
5. To specify the path to the driver, press <F3>. The window "Specify a directory path" is displayed.
6. Type the path to the driver. If you are installing from CD-ROM, the menu "Select an action" is displayed. Here, select
CONTINUE AND ACCESS THE CD-ROM. The menu "Select a driver to install" is displayed.
7. Select the driver for your network adapter. The driver is now loaded.
8. Select RETURN TO DRIVER SUMMARY.
9. Select CONTINUE.
10. To configure the protocols to be used, select ADD PROTOCOL.
11. Select RETURN TO THE DRIVER SUMMARY to finish the installation.
12. If desired, change the network adapter parameters or bindings in the autoexec.ncf file using the "Nwconfig" tool.
D-Link DGE-560T User Manual

Novell Netware 6.x