Symmons 262XBODY Troubleshooting

TROUBLESHOOTING
PROBLEM
Valve will not pass water.
Valve leaks when shut
Temperature control
turned from cold to hot (or hot
back to cold) and volume
spout or head is not constant.
Valve delivers sufficient
quantity of cold, but little
or the reverse.
Temperature varies without
moving handle.
Valve delivery temperature
reduces gradually during
handle must be turned
hotter positions to maintain
constant temperature.
Valve delivers hot water
initially opened. Water turns
colder as handle is rotated
counterclockwise direction
toward the hot position.
A WARNIN G:
This product
of California to cause cancer,
to www.P65VVarnings.ca.gov.
Symmons Industries,
Phone: (800) 796-6667
symmons.com • gethelp@symmons.com
Copyright @ 2020 Symmons
ZV-3405 REV O
CHART
Both hot and cold water
are not
off. Hot and
or foreign
lodged
seat surfaces.
handle is Pressure-balancing
housed
from restricted
by foreign
Same as above.
hot,
Same as above.
Overdraw
use; (i.e. running
to
Valve is piped
when
hot supply
in a cold inlet and the cold supply
piped
can expose
birth defects,
Inc. • 31 Brooks Drive
• Fax: (800) 961-9621
Industries, Inc.
CAUSE
supplies
turned on.
cold washers are worn
matter (dirt, chips)
between washers and
piston
in spindle assembly
from free movement
matter.
on hot water supply
out of hot water).
incorrectly (i.e. the
is piped to the valve's
to the hot inlet.)
you to chemicals including
or other reproductive
• Braintree, MA 02184
• 030220
SOLUTION
Turn on both supplies.
will not operate
and cold water
Replace washers
is washer repair
Replace hot & cold seats using
TA-4 hot/cold
Open valve halfway,
is handle and tap spindle
plastic hammer.
Check water
balancing piston
spindle. See service
instructions.
Replace TA-IO flow
spindle.
Same as above.
Same as above.
Reduce maximum
by using volume
adjustment on valve or
showerhead.
longer period
overdrawing
If piping is accessible,
connections
is piping is not accessible,
T-108 reverse
kit. Older installations
also require
hot/cold seat repair kit.
lead, which is known
harm. For more
Valve
unless both hot
pressure is on.
using TA-9
kit.
seat repair kit.
remove
with
pressure
in control
control
flow
control
This will allow
of use before
hot water supply.
correct
to the valve. If
order
seat and tool
may
replacing the TA-4
to the state
information, go