Juniper JUNOSE SOFTWARE 10.3.2 - RELEASE NOTES 9-29-2010 Release Note page 23

Deprecated Command
hostname
hssi description
hssi force dte acknowledge
hssi internal-clock
ignore dcd
ignore link-state-signals
[ no ] ike cr
l
interface hssi
invert tx clock
ip dhcp-local cable-modem
ip mirror
ip policy local-input
[ no ] ipsec isakmp-policy rule
ipv6 policy local-input
j1
license l2tp-session
lineCoding
log
log severity debug
dhcpLocalProtocolDecode
loopback
loopback remote { remote line fdl
ansi | remote line fdl bellcore |
remote line inband remote payload
[ fdl ] [ ansi ] }
mark
Command Mode Preferred Command
Domain Map Tunnel client-name
Configuration
Still available in Global
Configuration mode
Interface Configuration
Interface Configuration
Interface Configuration
Interface Configuration
Interface Configuration
Global Configuration [ no ] ipsec crl
Global Configuration
Global Configuration
Global Configuration set dhcp-relay with the
strings docsis and pktc in
the server-string mapping
specification
Global Configuration ip policy secure-input and
ip policy secure-output; for
E120 and E320 routers, you
must use these commands
because the ip mirror
command has been
removed from the CLI for
those routers.
Interface Configuration, None
Profile Configuration
Global Configuration [ no ] ipsec ike-policy-rule
Interface Configuration, None
Profile Configuration
Controller Configuration
Global Configuration None
Controller Configuration
Policy List Configuration log in Classifier Group
Configuration mode
Global Configuration log severity debug
dhcpCapture
Domain Map Configuration local-interface
Still available in Controller
Configuration and Interface
Configuration modes
Controller Configuration
Policy List Configuration mark in Classifier Group
Configuration mode
Release 10.3.2
15
Known Behavior