Field Controls 46453400 Manual page 6

8. Insert lamp through the hole until lamp cannot be inserted any further. (See
Figure 16)
9. Swing the swivel bracket over the end of lamp. Hand-tighten the wing nut on
the stud. Be careful no to over tighten the wing nut. The porcelain at the lamp
base may crack when over tightened. (See Figure 17)
10. Plug ballast plug into end of lamp. (See Figure 18)
11. Snap cover onto the unit base. (See Figure 19)
12. Plug the LED wire from the cover onto the board. (See Figure 20)
WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or
blindness. Never operate the UV-Aire™ Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your
hands.
Page 6
Figure 16
Figure 17
Figure 18
Figure 19
Figure 20