Find Ip Address - D-Link VTA-VR User Manual

Chapter  - Configuration

Find IP Address

The VTA telephone adapter has a built-in configuration utility. To access this utility, you need
to obtain the IP address of the VTA. By default, the VTA telephone adapter automatically
obtains an IP address from your DHCP enabled router or DHCP server. If you do not
have DHCP enabled, the IP address will automatically be set to 192.168.15.254. If you
do have DHCP disabled, you must use a 192.168.15.x network or statically assign the
IP address of a computer to 192.168.15.x (where x is between 1 and 253). You can then
connect to the configuration utility of the VTA and change its IP address to an available
IP address of your network. You will need to change your computer back to the original
IP address.
To find the IP address, log into your router or DHCP server and locate the DHCP table
(reference the User Manual for your router or DHCP server as necessary). The table
will display all of your network clients (using DHCP) that are connected. Search for the
Vonage VTA's MAC address in the table and the IP address will be listed next to it. The
MAC address is on the bottom of the Vonage VTA device.
Note: The terms MAC Address and MAC ID are used interchangeably.
D-Link VTA User Manual