Pppoe - D-Link DIR-605L User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a
username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your
computer. The software is no longer needed and will not work through a router.

PPPoE:

Select Dynamic (most common) or Static. Select Static if your
ISP assigned you the IP address, subnet mask, gateway, and
DNS server addresses.
User Name: Enter your PPPoE user name.
Password:
Enter your PPPoE password and then retype the password in
the next box.
Service Name:
Enter the ISP Service Name (optional).
IP Address:
Enter the IP address (Static PPPoE only).
MAC Address: The default MAC Address is set to the WAN's physical interface
MAC address on the Broadband Router.
Copy Your PC's You can click the Copy.Your. PC's. MAC. Address button to
MAC Address: copy the MAC address of the Ethernet adapter installed in
your computer to the router.
DNS Addresses:
Enter the Primary and Secondary DNS Server Addresses (Static
PPPoE only).
Maximum Idle Enter a maximum idle time during which the Internet connection
Time: is maintained during inactivity. To disable this feature, enable
Auto-reconnect.
MTU: Maximum Transmission Unit - You may need to change the MTU for optimal performance with your specific ISP. 1492 is the default MTU.
Connection Mode Select a schedule or click Add.New to create a new one. Then select either Manual or Connection.on.demand.
Select:
D-Link DIR-605L User Manual
PPPoE
17