Page 2
shall be used if required by NFP -70 (National Electric Code), federal/state/local laws, or local ordinances. If the use of a GFI is required Note: Time delay fuse or circuit breaker is recommended.
Page 6
Warm air out intake Drain Flexible tubing 3/8” ID pump model (included) 5/8” ID x 7/8” OD gravity model (not included) Potable water inlet 1/4” compression fitting 3-1/4” 2-1/2” (8.3 cm) (6.4 cm) 1-1/2” (3.8 cm) 115V 3-3/4” power cord (9.5 cm) 7-3/8”...
Page 7
Note: DO NOT build in so that the door is recessed. Door is meant to be flush with surronding cabinetry, but not recessed. Note: When installed, ice machine must be adjusted for height to position top of door to desired clearance. 13-9/16”...
Page 8
Use Upper Hole at the Inner screw Outer screw Screw Upper door bracket Accessory Door Panel Note: If door panel is attached, it must be removed to access hinge screws. Front screw Lower Bottom door screw bracket Insert door stop pin Gasket Machine Screw...
Page 9
Screw Note: DO NOT use self-piercing type valves. Service Access Panel Note: If you are connecting a gravity drain model and the drain opening has been located in the floor under the base pan according to the pre install specifications, follow steps 3 through 5 to drain the unit through the base. If not, proceed to step 6b.
Page 10
Grounding type wall receptacle Power Supply with 3-prong grounding plug Model and Serial number...