Connecting Access Points - Cisco AIR-WLC2106-K9 - Wireless LAN Controller 2106 Quick Start Manual

If the link does not activate, check the cable. When you are connecting to a hub or a switch,
Note
use a straight-through cable.

Connecting Access Points

After you have configured the controller, use Category-5, Category-5e, Category-6, or Category-7
Ethernet cables to connect up to 6, 12, or 25 Cisco lightweight access points (on Cisco 2106, 2112, or
2125 Wireless LAN Controller) to the network (distribution system) as shown in Figure 5. The
controller has an auto MDI feature, so you can use an MDI-X or MDI cable (crossover or
straight-through) to make the connections.
As soon as the controller is operational, the controller is available to connect access that are scanning
for a controller. When it detects an access point, it records the access point MAC address in its
database. The controller radio resource management (RRM) feature automatically configures the
access point to start transmitting and allowing clients to associate.
You have prepared the controller for basic operation. Refer to the Cisco Wireless LAN Controller
Configuration Guide for information on configuring the controller to meet the specific needs of your
wireless network.
18