Enable User Authentication Via Http / Https; Enable Radius Support - D-Link DFL-200 - Security Appliance User Manual

Enable User Authentication via HTTP / HTTPS

Follow these steps to enable User Authentication.
Step 1. Enable the checkbox for
User Authentication.
Step 2. Specify if HTTP and
HTTPS or only HTTPS should
be used for the login.
Step 3. Specify the idle-timeout, the time a user can be idle before being logged out by the
firewall.
Step 4. Choose new ports for the web-based management GUI to listen on since enabling
user authentication requires the default ports for user login purposes (80 and 443).
Click the Apply button below to apply the settings or click Cancel to discard changes.

Enable RADIUS Support

Follow these steps to enable RADIUS
support.
Step 1. Enable the checkbox for
RADIUS Support.
Step 2. Enter information for up to
two RADIUS servers.
Step 3. Specify which mode to use, PAP or CHAP.
Step 3. Specify the shared secret for this connection.
Click the Apply button below to apply the settings or click Cancel to discard changes.
34