Factory Defaults Button - NETGEAR ProSafe GS510TP Hardware Installation Manual

NETGEAR GS510TP Smart Switch
device such as a paper clip into the opening to press the recessed button. The front-panel
LEDs should extinguish and light again as the switch performs its Power On Self Test
(POST).

Factory Defaults Button

The Smart Switch has a Factory Defaults button on the front panel so that you can remove
the current configuration and return the device to its factory settings. When you enable the
Factory Defaults button, all settings including the password, VLAN settings, and port
configurations are removed. To operate the Factory Defaults button, insert a device such as a
paper clip into the opening to press the recessed button for two seconds.
Physical Description
15