Advertisement
Step 3 How do I connect the devices?
CAUTION
Before making any connections, make sure that the power to the Clavinova and the com-
puter is turned off. Connect a cable and set the [HOST SELECT] switch. Turn on the power
first to the computer, then to the Clavinova.
If you are not using the connection between the Clavinova and your computer, you must disconnect the
cable from the [TO HOST] connector or [USB] connector. The Clavinova may not operate correctly if a cable
is left connected.
If the Clavinova or the connected computer does not operate correctly after you make connection, the
power to the computer may be turned off, the cable may not be connected appropriately, the [HOST
SELECT] switch may not be set correctly, or the driver or MIDI application program on the computer may
not function.
In this case, turn off the power to the Clavinova and the computer, and check the cable connection and the
[HOST SELECT] switch setting. Then, turn on the power first to the computer, then to the Clavinova and
check to see if the driver or the MIDI application program functions correctly on the computer.
The connectors that can be used will depend on the setting of the HOST SELECT switch.
HOST SELECT switch setting
[MIDI]
[PC-2], [PC-1], or [Mac]
[USB]
Previous page
Table of Contents
Usable connectors
[MIDI] connectors (all: [IN][OUT][THRU])
[TO HOST] connector
[USB] connector
What is MIDI?
Possibilities
Connections
Glossary
7
Next page
Software
Advertisement
