Parameters For Kb3 Fxbus - Kurzweil K2661 Musician’s Reference Manual

rotation before you hear changes to tremolo when parameter values are changed. Negative microphone
angles take a longer time to respond to tremolo changes than positive microphone angles.
Figure 10-51 Acoustic beams for (i) low frequency driver and (ii) high frequency driver
You can control resonant modes within the rotating speaker cabinet with the Lo and Hi Resonate
parameters. For a realistic rotating speaker, the resonance level and delay excursion should be set quite
low. High levels will give wild pitch shifting.

Parameters for KB3 FXBus

Page 1
In/Out In or Out
VibChInOut In or Out
Vib/Chor V1
Page 2
RotoInOut In or Out
Lo Gain Off, -79.0 to 24.0 dB
Lo Xover 16 to 25088 Hz
Lo HP 16 to 25088 Hz
In/Out When set to "In", the algorithm is active; when set to "Off" the algorithm is bypassed. For
the entire algorithm to be active, KB3 AuxFX must also be active.
Out Gain The overall gain or amplitude at the output of the effect. For distortion, it is often
necessary to turn the output gain down as the distortion drive is turned up.
VibChInOut When set to "In" the vibrato/chorus is active; when set to "Out" the vibrato/chorus is
bypassed.
Vib/Chor This control sets the Hammond B3 vibrato/chorus. There are six settings for this effect:
three vibratos "V1", "V2", "V3", and three choruses "C1", "C2", "C3"
Roto InOut When set to "In" the rotary speaker is active; when set to "Out" the rotary speaker is
bypassed. By bypassing the rotary effect in KB3 FXBus, only the crossover filters are
bypassed. You must also bypass KB3 AuxFX to completely bypass the rotary speakers.
Likewise, for the entire rotary to be active, KB3 AuxFX must also be active.
(i) (ii)
Out Gain
Dist Drive
DistWarmth
Hi Gain
Hi Xover
Hi LP
KDFX Reference
KDFX Algorithm Specifications
Off, -79.0 to 24.0 dB
0 to 96 dB
16 to 25088 Hz
Off, -79.0 to 24.0 dB
16 to 25088 Hz
16 to 25088 Hz
10-117