Midi Indicator; The Demo Sequence - Kurzweil MICROPIANO Manual

After connecting the power, audio, and MIDI
cables, turn the MicroPiano on by rotating the
Power/Volume knob slightly clockwise until it
clicks. Within one second, all of the front panel
LEDs and all of the display segments will light
brießy. The LEDs then turn off, and the display
changes to show the software version number.
Finally, the Program LED will turn on and the
display will show a Ò1,Ó indicating that the
MicroPiano is in PROGRAM mode and is
operating normally.
Be sure your controller keyboard is
transmitting on MIDI Channel 1.
You may now begin to send MIDI signals
to the MicroPiano and adjust the Volume knob
and your audio system to a comfortable listening
level.
If the MicroPiano fails to operate as just
described, refer to the ÒIN CASE OF DIFFI-
CULTYÓ section on page 14.

MIDI Indicator

When you are sending MIDI signals on the same
channel on which the MicroPiano is set to receive,
the leftmost decimal point on the LED display
will ßash, indicating that you are receiving MIDI
messages.

The DEMO Sequence

To hear some of the capabilities of the MicroPiano,
try listening to the DEMO sequence. This can be
done by selecting CHANNEL mode and turning
the Data knob past 16. The display will look like
this:
and the DEMO sequence will play.
5