Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 9 Effects Manual page 21

Setting the FX Mode
To enable real-time control of the studio from the setup, we have to put the K2600 in the right
Effects mode. Go to the Effects-mode page, and set FX Mode to Setup. FX Channel
automatically goes to None.
EffectMode||||Xpose:0ST|||||<>Channel:1|
FX|Mode:Setup||
FX|Chan:None
Dither|:Medium||||||DigOut|:16|Bit
Octav-|Octav+|Panic|||||||||Chan-||Chan+
If FX Mode was Master before you switched it to Setup, youÕll notice that the Studio parameter
disappeared when you switched. ThatÕs because when FX Mode is set to Setup, you canÕt view
the current studio except from inside the setup. We do this so you canÕt make any changes in the
studio that the setup doesnÕt know about
The Setup
Now letÕs look at the setup that weÕre going to use to control our studio. Press Setup to go into
Setup mode, and select 200 KDFXCombo.
This is a four-zone setup, with bass and drums at the bottom, electric piano in the middle, and a
breathy ßute-like sound on the top. Each layer goes to a separate KDFX output pair, so they can
all get different processing.
If you edit the setup and look at the various zones, youÕll see this:
¥ Zone 1: Gtr Jazz Band, a layered bass and drum program, going to KDFX-A.
¥ Zone 2: Dual Slap Bass, also going to KDFX-A. This and the previous zone are active from
the bottom of the keyboard up to A3.
¥ Zone 3: Pno & Epno & Pad, an electric piano and pad program, going to KDFX-C, which is
#
active from A 3 to F
¥ Zone 4: Hybrid Vox, going to KDFX-A, and active from G5 and up.
#
5.
Basic Effects Mode
A Tour of Effects Mode
9-21