Backup And Copy Functions - Kurzweil K2500 - PERFORMANCE GUIDE REV F PART NUMBER 910251 CHAP 13 Manual

Disk Mode

Backup and Copy Functions

Backup and Copy Functions
File Backup
To access the Backup function from the Disk Mode page, first make sure that the Current Disk
is set to be the drive that you want to make a backup of. Next, press the Backup soft button:
Dir:\||||||||||||Sel:0/15||||Index:|||1|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||Set|backup|dir:ANIMALS|.KRZ||||1097K||
|||||||||||||||||BREAKAGE||||(dir)||||||
|||||||||||||||||LOWINST|||||(dir)||||||
Total:9040K||||||PLANKTON||||(dir)||||||
|Root||Parent|Open|||||||||Current|Exit|
On this screen, choose the directory tree that you want to backup by selecting a directory (see
Selecting Directories, near the beginning of this chapter.) Backup allows to you copy all of the
files within a directory tree from one disk to another. All of the files within the directory that
you choose, plus all of its subdirectories and files within them will be copied to the new drive.
If you want to backup the entire disk, then make sure the current directory is the root directory
(as in the picture), and press Current.
Next, you will see a dialog for choosing the destination disk:
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||Destination|disk:SCSI|0|||||||||||||
|||||||||||||||||||||SCSI|1|||||||||||||
|||||||||||||||||||||SCSI|2|||||||||||||
|||||||||||||||||||||SCSI|3|||||||||||||
|||||||||||||||||||||||||||||OK|||Cancel
Select the disk you wish to transfer files to. It must be a different disk than the current disk.
Next, you can select a directory on the destination disk that will receive the transferred files.
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Use|default|directory|on|SCSI|0?||||||||
(Path|=|\)||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||Change||OK|||Cancel
The default is always the root directory on the destination disk. Press OK to select the default.
To select a different directory, press Change.
Next, select the Backup mode when you see the following question:
13-62