Saving Files - Kurzweil K2500 - PERFORMANCE GUIDE REV F PART NUMBER 910251 CHAP 13 Manual

Disk Mode

Saving Files

You will see the following question after the current file being loaded is completed:
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Abort|the|load?|||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||||||||||Yes||||No||
It may be a good idea to practice using this method of aborting a multiple file load, so that
when the time comes that you accidentally select 100 files, you will remember how to abort the
process. This same method (of holding the Plus or Minus buttons down) is also used to abort
the Backup feature and the Macro file load feature.
If you run out of object or sample RAM, you will have one opportunity to abort the load as
explained above. However, if you continue from that point you may end up seeing the same
error message "Memory is full" for each file that you had selected. This can be a rather tedious
process, however it is still possible to abort out of this by holding down the Plus or Minus
button simultaneously while pressing "Yes" when you see the following question:
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Abort|this|partial|load?||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||||||||||Yes||||No||
More Load Function Enhancements
There are more features having to do with the Load function that are described later on in this
guide (i.e. loading Macro files, loading AIFF files, etc.)
Saving Files
The Save button starts the process of saving from the K2500 to the currently selected device.
When you press the Save soft button on the Disk Mode page you will see the bank dialog:
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||Save|selection:200...299|||||||||||
||||||||||||||||||||300...399|||||||||||
||||||||||||||||||||400...499|||||||||||
||||||||||||||||||||500...599|||||||||||
Export|Macro||Object|NewDir||Ok|||Cancel
The Macro soft button will only be present if Macro recording is turned on. (See page 13-38 for
more information on Macros.)
You can save an entire bank of objects, or by pressing the Object soft button, select individual
objects to be saved. If you choose to save using the bank method, all RAM objects within that
13-22