Kurzweil K2500 - PERFORMANCE GUIDE REV F PART NUMBER 910251 CHAP 13 Manual page 51

With all the entries selected, our display looks like this:
Func:MACRO|[Record]||||||||||Index:|||1|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
*4:\NEWMIX\TRASHX12.KRZ||||||||200:F:|||
*4:\POTS\TEAPOT.KRZ||||||||||||300:F:|||
*4:\PANS\FRYING.KRZ||||||||||||400:F:|||
*4:\KITCHEN\SINK.KRZ|||||||||||500:F:Obj
Select|Modify||Load||Pause|||Off|||Exit|
Two soft buttons have yet to be explained. They are Modify and Load.
Press the Modify soft button to change any items mentioned at the top of this section. You will
see the following display:
Modify|Macro|Entries||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Modify:Drive||||||||||||||||||||||||||||
Drive|:SCSI|4|||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
4|entries|selected.|||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||Delete||OK|||Cancel
This shows the screen that allows you to change the SCSI drive for the selected Macro entries. If
you increment the Modify: parameter, the display switches to let you modify Bank and Mode
information:
Modify|Macro|Entries||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Modify:Bank/Mode||||||||||||||||||||||||
Bank||:200's||||||Mode:Fill|||||||||||||
||||||||||||||||||||||||||||||||||||||||
4|entries|selected.|||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||Delete||OK|||Cancel
The initial settings of the parameters on these screens are always taken from the lowest indexed
Macro entry that is selected on the Macro page. In addition, every time you return to the
"Modify Macro Entries" page, both the Modify parameter and the cursored parameter field will
be the same.
Pressing OK will set all of the selected Macro entries to have drive ID or Bank and Mode
settings according to the parameters set up on this page. The display will return to the Macro
page with the same entries still selected. Any modifications to the parameters will be visibly
apparent. Selecting multiple entries for editing allows you to change those entries in a uniform
way. In our example above, you could change the Macro so that all the files were loaded into a
single bank, instead of the separate banks they had previously been loaded to.
Press Delete to remove the Macro entries from the Macro list. You will see the display:
Disk Mode
Macros
13-51