Light Bulb Replacement; Surface Care; Surface Care - Ultralife® And Colored Shells - Dimension One Spas Bay Collection Owner's Manual

Light Bulb Replacement

All systems are equipped with Dynamic LED Light bulbs. To change the bulb:
1. Turn the power off and drain the system below the level of the light.
2. Using the special tool provided in the owner's manual packet,
unscrew the cover for the light housing.
3. Remove the old bulb and install the new bulb.
4. Use the special tool to replace the cover for the light housing.
5. Check to ensure proper operation of the new bulb before refilling
the system.
Do not attempt to remove the light housing cover without lowering the water level below the light
housing cover.
Do not attempt to remove the light housing cover without the special tool. If you are not able to
locate it, contact the Dimension One Spas' Service Department to have one sent.
Be sure the O-ring is not damaged and is properly in place when replacing the lens. Contact
Dimension One Spas if a replacement O-ring is needed.

Surface Care

Surface Care – Ultralife® and Colored Shells
Your equipment has a very high quality finish. Stains and dirt will generally not adhere to the surface. We
recommend using a "cheesecloth" rag to clean the entire shell surface with Dimension One Spas Inc. Water
Line Cleaner. You may also use ph/Alkalinity Increaser or a 50/50 solution of denatured alcohol and
water. Be sure to thoroughly rinse the shell. After cleaning, you will want to restore your hot tub shell's
original luster by using Dimension One Spas Inc. Poli-Gloss.
Do not use "409" type cleaners or other caustic solutions as they may damage the hot tub shell
surface and void the warranty. If you are using baking soda to clean your hot tub shell, be careful
not to get it on the skirt. It may bleach the wood.
Do not use citrus-based cleaners on the shell surface.
2004 Bay Collection
Owner's Manual
51